PID Test System (Single Control Scheme)
Meet the PID test requirement specified in the IEC62804 standard.
l The frame end of the module is grounded, which not only simulates the actual situation, but also prevents the potential danger caused by the high pressure of the frame during the test process
l For each module, use the 4-wire test method, that is 2 high-voltage cables, and 2 ground cables. The high-voltage cables are connected to the inside of the module through the terminal box. The ground wire is connected to the frame or connected to other effective positions
l Multiple currents are displayed at the same time, while alarm parameters are set separately, with single-circuit on/off control
l Multi-channel voltage settings are programmed separately and the voltage can be set as required.
l Forward and reverse voltage could be set by program;
l Conversion of positive power supply and negative power supply, which is simulation of positive ground or negative ground.
l Can set test time, and stop automatically;
l The screen shows the test situation, and record the test data;
l Test channels can be customized according to customer needs;
l Can test and record environmental parameters and temperature parameters.
Alarm setting range
|1～1000 uA /-1000 uA～1|
Can be set
Temperature control stability
Meet the heating rate of 5°C/min.
Humidity control range
Humidity control stability